GSXR600 07 front end on 07 SV1KS - SV1000 Portal
LinkBack Thread Tools Rate Thread Display Modes
post #1 of 3 (permalink) Old 13th February 2017, 06:29 PM Thread Starter
Scooter boy
daniell61's Avatar
Join Date: Oct 2016
 ♂ United States
South Florida
Posts: 50
Smile GSXR600 07 front end on 07 SV1KS

any tips/tricks/suggestions for doing the install?

I have the full SV1 rim and good rotors on it and im getting the entire GSXR600 front end (with a GSXR1000 2005 upper triple for the fork lock) including clip ons and all that

I've seen several threads for the 650 but few if any for the 1000. more of just a before/after photo

Been told its pretty much bolt on so I feel it'll be easy once I figure out the jack setup

and if anyone has assuming for the triple bearings one goes on bottom and one up top?

2007 SV1000S bought 4600.
at:5500 miles
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
daniell61 is offline  
Sponsored Links
post #2 of 3 (permalink) Old 13th February 2017, 10:38 PM
L-Plate Rider
Join Date: Feb 2017
 ♂ United States
Commerce City, Colorado
Posts: 5
"once I figure out the jack setup" I have my 06 on a rear stand and standard jack stands right now doing a similar but different set of work. I used my front and rear stands to get the bike off the ground, then used my floor jack to raise it about two more inches and supported the front from the bolts on the oil radiator using two car jack stands. Its probably not the best way to go about it but it works and is stable enough to hammer out the races in the steering head without it falling over.
06SV1KS is offline  
post #3 of 3 (permalink) Old 14th February 2017, 01:44 PM
Hardcore Biker
Join Date: May 2012
 ♂ United States
Alameda, CA
Posts: 602
I'd recommend picking up a new set of steering head bearings while you're in there. Our bikes are old enough that it's worth doing.

I use jack stands under my frame sliders when I need to remove the triple.
Junkie is offline  

front end swap, gsxr 600, gsxr fork swap

Quick Reply

Register Now

In order to be able to post messages on the SV1000 Portal forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes Rate This Thread
Linear Mode Linear Mode
Rate This Thread:

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome