Hi all. Having the an issue with the power commander. Initially it was a jumpy tps reading in the power commander software. I ran a tap from the TPS ground to the two ground wires from the PC harness that taps into the battery. Now the TPS is steady and very consistent at idle but now the rpm reading is jumpy and the bike runs very poorly, overly rich at idle, and stalls after idling up to operating temp (it does shoot a very nice blue flame out the back though!) From what I'm understanding from the board here, does the digital ground wire (black w/ white stripe on PC harness to battery, is that the correct wire?) need to be rerouted to the TPS ground instead of the battery?