:Attn:Here is some backgroung info: sk3- Yosh 3/4 trs system, K&n ,no snorkel, tank spacers, Pair blocked, no exhaust leaks, AMR TRE pluged in, pcIIIusb ( I have tried all maps, and moded m314-003 +2 in rpms ranges 4500 to 5000 all throttle positions), pcIII throttle position reset. It only has...
The PCIII lights up when I turn my bike on, goes through the light sequence, and then turns off (I hear a click that isn't necessarily from the pcIII). SHouldn't there be a light on when the PCIII is operating? Then basically, I cannot get ignition, just like if the PCIII were disconnected...
Okay guys, before I get flamed, I did use the search. I finally got my PC-III installed today and everything was going nicely. After I got it all put back together though, the FI light started flashing on the next startup :wallbash: . I have an 05 1KS with K&N air filter, Scorpion bolt ons...
I've been looking around the site and found the section in the FAQ where people say that running bolt-ons on the SV1K's are find without a PCIII, and also that the bolt pattern from the TLR/TLS are the same. I found a good deal locally for some Titanium scorpions from a '01 TLS...
i got another issue that started when i fitted PCIII
When i start my bike - (from cold) the revs go up for a while (as you would expect), but after about 1 , 2 minutes they go low and then the bike stops
If i start my bike when engine is hot - no issue at all - the revs are about 1K
I need advice what to do with my bike
I fitted full 2-1 Yoshi system yesterday with O2 sensor ( i removed sensor from old pipes and fitted it into yoshi - there was space for it)
now i got FI light constantly on
The bike runs all right - I even noticed slight improvement (I used to get kind...
I just ordered Yoshi 3/4 system for my SK3 as well as PCIII
Do I need to go to garage after installation to have my bike remapped or can i do it myself with PCIII?
do I still need TRE to improve throttle response?
This may be a shot in the dark but I am trying to get a map for the IXIL underseat exhaust. I know a few European riders have this exhaust but I can't find a map and going get the bike tuned right now is impossible. Any help?