SV Portal Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Yeah.....just gently prise it off, see if you can force it outwards into your hand, rather than lifting the end....clean and prep the rotor for filling the gaps.....then clean the back of
the loose magnet and rotor with some grit paper, cleaning again.....and put the thinnest smear of JB on the back, clamp it in place for 4 or 5 hours and while you are waiting
for it to set, fill the rest of the gaps.......
Over the years have you tried one of the mosfet regulators with much success or just JB weld and keep riding with the std regulator ?
 
1 - 1 of 1 Posts
Top