SV Portal Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
283 Posts
Discussion Starter · #1 ·
I bought a 650S gauge cluster off ebay for my 1000N - conversion done with N triples and gauge pod mounted onto the triple.
Will the X bracket from the 650 fit the N upper triple ?
Or will the 1000 X bracket fit the 650 gauge.
 

·
Registered
Joined
·
283 Posts
Discussion Starter · #3 ·
The X bracket for 650 and 1000 are different numbers. So are the gauges.
But is that due to the difference at the triple only - in which case I need the 1K bracket, or difference at the gauge only - then I need the 650 bracket, or both which = I'm screwed. Have to hand fab.
 

·
Registered
Joined
·
283 Posts
Discussion Starter · #4 ·
OK I think I finally used biker bandit's search tool. The X bracket is unique to the 1000. The back cover, little bracket on it etc are shared with 650. The gauge bottom panel also shared with 650. So I need the 1000's bracket. And the rest are the same.
 

·
KNEE DRAGGER
Joined
·
5,182 Posts
OK I think I finally used biker bandit's search tool. The X bracket is unique to the 1000. The back cover, little bracket on it etc are shared with 650. The gauge bottom panel also shared with 650. So I need the 1000's bracket. And the rest are the same.
I have had both in hand. If I remember correct the mounting width at the top clamp were different.

-ms
 
1 - 6 of 6 Posts
Top